Osteometer Measuring Forcep

Osteometer Measuring Forcep

Three measurements separate a successful implant from a failed one, bone width is the first. The Osteometer Measuring Forcep reads alveolar ridge width directly at the bone surface, bypassing the soft tissue overestimation that radiographic and cast-based methods carry. Constructed from AISI 304 medical stainless steel with a high-polish rust-free finish, it measures 155mm in overall length and covers a ridge width range of 0 to 25mm. The instrument operates on a reverse-scissors mechanism: two crossed arms pivot at a central screw joint, with ring handles at the base and two fine pointed tip-pins at the working end. Squeezing the ring handles spreads the pointed tips apart, the spread distance equals the measured bone width. Millimeter graduation scales are marked on both arm faces, readable from either side without reorienting the instrument. The Leader Surgical brand mark is engraved on one arm.

The pointed pins penetrate the overlying mucosa at the alveolar crest and contact the buccal and lingual cortical bone surfaces directly. This transmucosal measurement gives the actual bone dimension; not the soft tissue envelope, which determines the maximum implant diameter that can be placed without cortical perforation. The instrument is fully autoclavable and CE compliant.

Oral surgeons and implantologists use the Osteometer Measuring Forcep during pre-implant ridge mapping, taking direct transmucosal bone width readings at planned implant sites before osteotomy preparation. The osteometer reading at each site is recorded against the implant diameter selection chart, replacing or confirming CBCT-based estimates intraoperatively.

Leader Surgical manufactures this forcep with verified scale-graduation accuracy across the full 0–25mm range, meeting the dimensional traceability requirements of the orthopedic instruments catalogue and implant surgery protocols under ISO 13485 standards. The Measuring clamp format is the intraoperative standard for ridge mapping across implantology practice.

What is an Osteometer Measuring Forcep used for?
It is primarily used in oral and maxillofacial surgery to measure the width of the alveolar ridge. This is critical for planning dental implants to ensure there is sufficient bone volume for stable placement.