Bracket Removing Plier Length 13.5cm

Bracket Removing Plier Length 13.5cm

The Bracket Removing Plier Length 13.5cm measures 135mm in total length and is built from medical-grade stainless steel with a high-polish finish. The jaw assembly carries two wide, flat-edged straight tips that align parallel to each other without angular offset, a geometry optimized for anterior tooth access where direct frontal approach is unobstructed. The most structurally distinct feature of this instrument is the knurled tension-adjustment screw mounted on one handle arm, clearly visible in the product image. This screw pre-sets the inter-tip gap before intraoral placement, allowing the clinician to match jaw width to the specific bracket size and control engagement force without intraoral repositioning.

The straight tip faces seat against the mesial and distal tie-wings of the bonded bracket simultaneously. A single controlled compression stroke delivers a shear force at the bracket base, fracturing the adhesive interface and releasing the bracket from the tooth surface. This force delivery method keeps bracket deformation low, important when brackets are being recollected for reuse. The instrument works across metal, ceramic, and plastic bracket types. It is fully autoclavable at 134°C. The Orthodontic Bracket Remover Plier-13.5cm designation identifies this straight-tip, screw-adjusted variant in international orthodontic catalogs.

Orthodontists use the Bracket Removing Plier Length 13.5cm during fixed appliance debonding sessions, removing bonded brackets from anterior teeth (incisors and canines) where straight tip alignment delivers maximum wing engagement and clear operator visibility. The Bracket Removing Plier Straight configuration is the standard choice for anterior debonding when access angle is not a limiting factor.

Leader Surgical builds this instrument with verified tip-face parallelism and a calibrated tension screw that retains its set position across full autoclave sterilization cycles, ensuring consistent jaw gap and repeatable debonding force session to session.

How do I use this plier to avoid damaging tooth enamel?
The correct technique involves placing the beaks at the adhesive-bracket interface and using a gentle squeezing motion rather than a pulling force. This breaks the bond cleanly without stressing the tooth surface.